We hope to make your sign purchase as seamless as possible. Please see some FAQ's below that may help you through the process.
To produce the best quality image on your sign, we like to work with vector files. We prefer to work with: .ai, .eps, .pdf, or high resolution .jpegs.
Contact us today to get all of your sign needs!
Timeframe depends a lot on what type of sign you are ordering. Our standard timeframe is between 2-3 days after getting estimate and proof approval. When working on larger or more involved projects, our timeframe may be longer.
Use the following steps to install your graphics. As always, if you have any questions, you can always call us.
Below are a few tips on how to care for your signs:
Surfaces may be cleaned with any household cleaner such as Fantastic or 409. Wipe area clean and dry with a lint free cloth before applying the vinyl graphics. Freshly painted surfaces should be dry for at least 72 hours prior to application of the vinyl graphics.
Using small tabs of masking tape, tack the graphic to the intended surface. Measure to be sure it is in the proper place.
Apply a single horizontal strip of masking tape to the top of the graphic. This strip will be used as a hinge that will ensure the graphic does not move during the application process.
Hold the bottom edge of the hinged graphic away from the intended surface and remove the liner to reveal the sticky backing of the vinyl.
While still holding the hinged graphic away from the surface, use a squeegee starting from the top and working your way out side to side. Press firmly to ensure proper adhesion.
Pull the mask off at a 180-degree angle.
Pop any air bubbles by poking a small hole at the edge of the bubble and pressing all air toward the hole with your finger.
For a digital print banner, always loosely roll the image on the inside.
For a cut vinyl banner, always loosely roll the image on the outside.
NEVER fold your banner.
Keep your banner away from solvents such as: paint thinner, alcohol, and acetone.
Make sure your banner is completely dry before you roll it up.
Magnetics must be applied to a clean, flat, steel surface. Avoid applying your magnetics over any corrugations, creases, moldings, or other objects.
Clean magnetic signs with a mild detergent, and never let moisture accumulate on the back of the magnetic. If there is moisture on the back of the magnetic, wipe it off with a clean paper towel or cloth. ALWAYS REMOVE YOUR MAGNETIC SIGNS BEFORE GOING THROUGH A CAR WASH.
When not in use, keep the magnetics on a clean, flat surface. Never roll your magnetics or allow them to sit on a curved or bumpy surface.